Causes and solutions of eccentric shaft bending of jaw crusher

The eccentric shaft plays an important role in the operation of the jaw crusher, but there is a problem in the use of problems, and we only find out the faults, specific problems are specific to the specific analysis to eliminate it more quickly. So, what are the common faults of the jaw crusher eccentric shaft?

Causes and solutions of eccentric shafts:

1, the host side A rollover occurs during the host lifting process of the jaw crusher, so that the eccentric shaft is unilaterally bent, and the severe case should be replaced and strive for the new replacement of the lifting.

2, material hardness dyeing standard If the material given is too hard, the range of the crushing of the jaw crusher can cause an eccentric shaft; therefore, the material hardness should be controlled, and the compressive strength of the crushing material is selected, and the comparable crushing machine is selected.

3, the elbow does not meet the standard When this is the case, it should be assessable, and it is strictly forbidden to use an elbolate and an elbola mat without a design standard.

4, miscation is improper When the eccentric sleeve is not spread in time, it is easy to cause the short-term breakage; at this time, the appropriate method is to replace the new eccentric shaft and use the heat treatment qualified eccentric shaft.

5, the host is dyed for a long time It should be downturn in time, and the operation load or replace the comparable crusher should be corrected.