Why the output of hydraulic cone crusher is slow

Hydraulic cone crusher is a kind of crushing equipment with relatively * structure. It can be widely used in many areas of crushing operations such as mines, constructions, road repairs, etc. It also has the advantages of large crushing ratio, high operation efficiency, and uniform product particle size. Liked by a wide range of users. Some friends of Ran Jin reported that after using the cone crusher for a long time, the discharge was too slow. Here, the editor will briefly talk about the reasons for the slow discharge of the hydraulic cone crusher during operation.

The editor here will briefly talk about the reason why the cone crusher is too slow. In fact, there are many reasons for the slow discharge of the hydraulic cone crusher. If you want to deal with the slow discharge, you must find out the corresponding reason, so that you can deal with the problem of blockage well.

1. The * common problem of cone crushing and material blocking is that too much material feeds the equipment, which causes the problem of accumulation and even material blocking. This situation will cause the equipment to discharge slowly. When we run the equipment, we must feed the material at a uniform speed, so that this situation can be avoided.

2. The water content of the processed material is too large. If the stone material to be processed has a high moisture content, after entering the hydraulic cone crusher crushing cavity, following the work of the equipment, under the strong kneading action, it is inevitable that there will be adhesion and adhesion, and even blockage, which is *ly reduced. The crushing capacity of the equipment to the material, the * dyeing constitutes the hydraulic cone crusher and the discharge is slow. 　

3. The feeding amount is too large. In our use of hydraulic cone crusher for material processing, if too much material is put into the crushing cavity and occupying part of the space in the crushing cavity, the crushing space of the material will be reduced, and then the material will be discharged slowly after crushing. 　

4. The size of the discharge port is incorrect. When the size of the discharge outlet of the hydraulic cone crusher is not appropriate, it simply constitutes that the materials that have been crushed and qualified are too late to discharge in time, and then the material accumulation is blocked, which affects the crushing of the stone, and then causes the hydraulic cone crusher to discharge slowly.