How does the cone crusher work

At present, China's infrastructure construction is constantly improving, and the demand for aggregates is also expanding. In the production of sand and gravel aggregates, jaw crushers, cone crushers and impact crushers are increasing, and users are gradually increasing.

    How does the cone crusher work in the gravel production line? The following is the crushing process of the cone crusher. First, the materials entering the cone crusher should be evenly fed into the cone crusher crushing chamber from the cone crusher distribution board, otherwise it will cause the cone crusher to be overloaded, and make the cone cone movable cone bushing And fixed cone lining premature wear and reduce the production capacity of cone crusher and produce uneven product size. At the same time, the ore entering the cone crusher is not allowed to enter the crushing chamber of the cone crusher only from the side of the cone crusher. The feed size of the cone crusher should be controlled within the specified range.

    In order to make the cone crusher safe and normal production, we must pay attention to the condition of the hydraulic cylinder in the operation of the cone crusher. If the hydraulic cylinder is under normal tension, but the support ring jumps frequently, you do not need to take any measures to adjust the hydraulic cylinder. Instead, you must find out why the hydraulic cylinder is propped up. In addition to entering non-broken objects, it may also be caused by a cone crusher. Due to uneven or excessive ore, the size of the cone crusher outlet is too small, and wet ore blocks the cone crusher outlet.

    In order to maintain the width of the cone crusher discharge port, the adjustment ring should be rotated clockwise every two or three days to make it slightly lower according to the wear of the cone crusher lining, so that the gap of the cone crusher discharge port can be reduced. The port is worn out. If the adjusting ring of the cone crusher rotates 2-2.5 clockwise, and the size of the discharge port of the cone crusher is still not enough, the bush of the cone crusher must be replaced. When the cone crusher s*s running, it should be s*ped on the miner *. After the ore in the crushing cavity of the cone crusher is completely discharged, the motor of the cone crusher s*s running, and the oil pump * *ly s*s running.