What inspections need to be done on the cone crusher before starting

Cone crusher is currently one of the * widely used crushing machinery and equipment in the mining industry. It is widely used in construction of mines, railways, bridges, roads, etc., and has good *, so he receives many users Favorite.

Before starting the cone break, you need to check whether the equipment is normal. Especially for the parts of the crusher, it is necessary to check carefully. In order to ensure the smooth and efficient operation of the cone crusher and ensure the maximum production efficiency, we only have to do these things, so there is no future worry.

Of course, before starting, in order to ensure the effect of the operation, there are some precautions to be prepared. Let ’s take a look at the specific precautions for each component.

The * fuel tank, before starting, the * thing to do is to check whether the fuel volume in the fuel tank is full and add it as soon as it is found to be insufficient. When an oil leak occurs, it must be repaired in time to ensure that there will not be any trouble with the hydraulic oil.

The second discharge port, the discharge port of the crusher should be checked regularly and regularly. The discharge port is where the finished product comes out. It is very critical and directly affects the output and quality. Once the discharge opening is found to be too large or too small, it must be adjusted in time, otherwise it may cause product quality problems and affect production.

The third lubrication system, the reason why the cone crusher can operate normally, the role of the lubrication system is huge. The raw materials of the parts of the crusher are generally steel castings, etc., which are susceptible to rust. Generally, certain lubrication is required to ensure the normal production.

The fourth frame, before the cone crusher runs, a detailed inspection of the equipment frame. In order to ensure that no mistakes occur during work, it is necessary to ensure normal contact between the rack and the base without looseness. If you find that the screws are not tightened, inform the operator in time and tighten the screws.