Introduction to the method of increasing the output of cone crusher

As one of the * common mine crushing equipments in domestic mine production lines since the 21st century, cone crushers have played an important role in the whole mine crushing production. For an *mine operator, how to increase the output of the cone crusher is critical.

Over the years, with the gradual hotening of the mine crushing market, cone crushers have also created a situation of short supply. After continuous practice research, Jiaozuo Zhongxin found that the crushing output of the cone crusher can be adjusted by adjusting the size of the closed-end discharge opening. The smaller the size of the closed discharge port, the smaller the output of the cone crusher and the better the quality of the finished product discharged. Conversely, the larger the size of the closed side discharge opening, the larger the cone bankruptcy, but the worse the quality of the discharged finished material. That is to say, the mine production and management operators can control the size of the side discharge opening of the cone crusher according to their own market demand, so that the choice between quality and output can be made. Then, in the daily mine crushing production process, how to improve the production efficiency of the cone crusher?

First, when feeding the cone crusher, the * feeding machine needs to meet the inlet particle size requirements of the cone crusher. If the feeding is too much or too little, the cone crusher will not achieve the * crushing efficiency.

Second, the mine staff should always pay attention to the broken discharge of the cone crusher discharge port, and control the running speed of the conveyor belt feeder to ensure timely and normal feeding and arranging of the cone crusher. material.

Third, the staff at the mine crushing site should regularly check the drainage of the water seal dustproof. If there is no water or the water volume is very small, the mine crushing production should be s*ped to prevent the crushing work of the cone crusher.

Fourth, the mine staff should regularly check the wear of the wear parts of the cone crusher, especially the wearing parts such as lining plates and dental plates, and it is necessary to pay attention to the timely adjustment of the lining plate fixing bolts on the ring. If it is loose, it will cause the lining to loosen, which will cause damage to the cone crusher in the long run.